The Keysight Technologies, Inc. Medalist i3070 light emitting diode (LED) test delivers uncompromising
repeatability and accuracy in LED color and luminosity measurements with superior throughput during
i3070 in-circuit test. It returns the LED color value and luminosity in nanometers and μW/cm2 to
accuracies of ± 3 nm and ± 10% respectively. It can test up to 128 LEDs in less than 1.3 seconds,
increasing your i3070 test capacity, which translates to lower cost of in-circuit test.
The i3070 LED test consists of:
i3070 LED sensor
i3070 LED signal conditioner (mux)
i3070 LED test card
i3070 LED test box
i3070 LED starter kit
i3070 LED software tools (i3070 release 8.3 and greater)
i3070 runtime integration (i3070 release 8.3 and greater)
The i3070 LED test sensors and LED signal conditioner (mux) card are installed in the i3070 test fixture
similar to our VTEP solutions. Thirty-two i3070 LED test sensors can be wired to each i3070 LED signal
conditioner (mux) card, and four i3070 LED signal conditioner (mux) cards to one i3070 LED test card in a
Utility Card or an i3070 LED test box. The i3070 LED signal conditioner (mux) card in the fixture is then
connected to the i3070 testhead electronics via the i3070 LED test card plugged into a utility card or a
i3070 LED test box. The i3070 LED test box saves a hybrid card slot and is mounted within the i3070 test
head.
Comments
Post a Comment