12.0 TEST STATION READINES – System Selftest Program
12.1
The system selftest program can only be executed while logged in under
the service1
account.
12.2
At the system log in window, refer to figure 3, type in service1 and
click the mouse
on the “OK” button displayed on the screen or press
the “ENTER” key on the keyboard.
12.3
The system will then prompt you to enter the proper password for the
account that you
are logging in under. Click the mouse on the “OK” button displayed
on the screen or press the “ENTER” key on the keyboard.
12.4 Place the system self test fixture, refer to figure 10, onto
either bank 1 or 2 of the testhead.
Orient the test fixture so that the test points are towards the center
of the testhead. Ensure that the
protective cover is installed over the unused bank.
FIGURE 10
12.5 A “diagnostics” window will appear on the
screen, refer to figure 11.
12.6
Follow the on screen instructions to highlight the “System Diagnostics”
selection.
12.7
Click the mouse on the “Enter” softkey, or press the F1 keyboard key.
12.8
This will bring up the “System Diagnostics” window, reference figure
12.
Comments
Post a Comment