5.0 LOGGING
ON THE SYSTEM
6.1 When you first power up the test station,
the operating system loads the necessary
software to initialize. When this “boot-up” process is complete, you
will see a log on window similar to that shown in figure 3.
6.2 Trained
and certified test operators may log in as user1. All other operators must log in
as operator.
FIGURE 3
6.2 Type
in the appropriate username at the log in screen and click the mouse on the
“OK”
button displayed on the screen or press the “ENTER”
key on the keyboard.
6.3 The
system will then prompt you to enter the proper password for the account that
you
are logging in under. Click the mouse on the “OK” button displayed
on the screen or press the “ENTER” key on the keyboard.
6.4 Following the process defined in the Test
Department Procedure , SOP-3-1002-9,
identify
and locate the In-circuit Test Fixture required for the UUT to be tested.
6.5 Removed
the testhead covers as required and install the test fixture. Unless otherwise
instructed
the single bank test fixtures are installed onto bank 2 of the testhead.
Comments
Post a Comment