7.2
If the load is successful then an HP3070 testmain will
be displayed on the screen. In addition the
HP Board Graphics Viewer may be displayed as well.
7.3
Execute board testing as per paragraph 5.6 of the
HP3070 Operating Procedure ,
SOP-3-1031-9.
7.4
When all testing is completed for this board type,
execute the “exit” command, F8 softkey on the testmain window. This will return you to the window shown in
Figure 4.
7.5
Execute the “test fixture unlock” command, F3 softkey.
7.6
If there is another UUT type to test, repeat
paragraphs 7.3 through 7.8. If all
testing is completed. Execute the “quit”
command, F8 softkey.
7.7
This will bring up a window similar to that shown in
Figure 5. Execute the “exit” command, F8
softkey to log off the tester.
7.8
Remove the test fixture from the testhead and install
the testhead covers.
Warning: The
testhead covers must always be installed whenever there is
no fixture on that portion of the testhead.
This protects the interface pins from damage and contamination as well
as helps the tester maintain a constant
internal testhead temperature.
Comments
Post a Comment